My beloved car Babe2 has been acting up again. This time the breaks decided not to fully work, and after 2 close accidents I decided not to drive yesterday and today, since I am on leave, I got my babe looked at. What was the problem? Well, there was more than 1 problem, but the main issue was the device that supplies the break fuild was faulty and needed to be replaced. My break pads for the two front tyres were getting rather thin, so they needed to be replaced, and the break disk was also uneven, and needed to be evened out. There was a seperate issue on the back tire where the bearing needed to be replaced. All in all, including labour was RM415. Sigh.
My Babe2
Freshly evened out disk
Faulty Break Liquid Dispenser
The new one installed
On this day in History..
- I am in Mourning! - 2006
- Where exactly did you learn how to drive? - 2007
- Happy Mothers Day! - 2008
- Down-Under Dayz : Bondi Beach, NSW, Australia - 2008
- JJCM :- Little Korea, Solaris - 2009
- Terence and Cheryl Wedding - 2009
wow.. that’s expensive for a proton..
hope the Babe2 is well and about now..
cheers